Dhcp pxe scope options Configuring IP Helpers on your network to point to the WDS server will achieve the same goal. And also authorize this WDS server in DHCP. Server IP address is xxxxx, nbp filename is smsboot\x64\wdsnbo. microsoft. Right-click on the new scope and select “Configure Options. nbp file download successfully. . On the Boot Server Host Name add the FQDN or IP for the PXE/WDS server. It then shows a white screen with secure boot, selected boot image did not authenticate. This option will need to be manually set on the DHCP server if: You need to get rid of any and all DHCP options related to PXE boot. com. To activate the scope right click on the scope and select “Activate”. Enable option 67 (Boot File Name) and set its value to pxelinux. com for SCCM if WDS by itself then set Boot\x64\wdsnbp. com nb filesize is 30952 bytes, downloading nb file. If not, please reboot your server and then activate the scope. Right-click on the new scope and select “Configure Options. Save the changes and activate the scope. ” Enable option 66 (Boot Server Host Name) and set its value to the IP address of the TFTP server. com/t5/configuration-manager-blog/you-want-to-pxe-boot-don-t-use-dhcp-options/ba-p/275562. On the Scope navigate to Server or Scope Options the configure new options 066 and 067. If a DHCP response contains option 060 with the value of "PXEClient," the client computer will make further PXE requests to that specific computer. 0. Set the Do not listen on DHCP ports. If you are configuring DHCP after WDS, please check to make sure that option 60 has been added in to the Server Options section. Start PXE over IPV4 IP address is xxxxxx. On the Bootfile Name add SMSBoot\x64\wdsnbp. Using the above mentioned DHCP Options will permit you to PXE boot your clients across both VLANs and subnets with both 32bit and 64bit images. See https://techcommunity. pstfeu wan agweqi oqonnp cglt vjrtv cdqmxtj qlgcl bwoq wzfo